Trenchless in-situ pipe rehabilitation technology minimizes maintenance costs and system down-time.
Cleaning and repairing deteriorated water or sewer pipelines helps improve system efficiency and protects both your community and the environment. The task can be daunting and expensive, especially when excavation is required.
Spray-in-Place Pipe Lining Repair and Rehabilitation
Veolia provides an innovative spray-in-place pipe (SIPP) lining rehabilitation process that scrubs underground pipes clean before applying an epoxy lining for in-situ pipe repair. Designed by Warren Environmental, the 2-part component epoxy material is ANSI/NSF Standard 61 approved for potable water supply. Once cured, the epoxy lining provides long-lasting protection to your sewer or water pipes, which helps reduce the frequency of maintenance and pipe replacement. This trenchless rehabilitation technology minimizes maintenance costs and system down-time.
A Trenchless, Long-Lasting Solution
Veolia spray-in-place pipe lining repair process (SIPP) is an efficient and long-lasting pipe rehabilitation solution that uses a spray nozzle attached to a state-of-the-art, computer-controlled robotic spray rig to apply an internal epoxy lining in an already existing pipe. No major road or sidewalk tear-ups are necessary. Once cured, the lining seals the pipe, preventing leaks and water contamination, improving flow capacity and minimizing future maintenance costs. This rehabilitation technology works on pipes made of different materials and ranging from 4 inches to 36 inches in diameter.
Value of Veolia Spray-in-Place Pipe Repair and Relining Solutions
- Extends service life of water or sewer pipelines
- Reduces frequency of maintenance, minimizes repair costs and system down-time
- Enhances flow capacity and system efficiency
- Prevents leaks and water contamination
- Protects against future corrosion and degradation
How does Veolia Spray-in-Place Pipe Lining Technology Work?
Veolia's spray-in-place pipe rehabilitation process consists of four steps:
- Agree with the utility on the access point location, then dig an access pit one foot below the host pipe. A three-foot section of the host pipe is removed to allow access to the relining equipment. Confirm the section of pipe to be restored utilizing closed-circuit television (CCTV).
- Preparation of the pipe interior by drag scraping, and/or hydro-jetting to create a clean, smooth dry surface.
- A second CCTV inspection follows to determine if there are any leaks, infiltration or repairs that are needed outside of the SIPP scope of work. Any repairs needed to address current piping issues are undertaken without the need for additional excavation, and to ensure that the pipe is properly prepared for the epoxy coating.
- The epoxy coating is then applied and, once cured, we do a final CCTV to make sure the lining is correct. We reassemble the sections of pipe that were removed at the access points. The utility proceeds with the chlorination/disinfection before system restoration.
Once cured, the spray-applied epoxy pipe lining creates an internal seal that prevents leaks and helps protect against future corrosion and biological buildup in your water main. This extends the pipes' service life, helps reduce the frequency of maintenance, and increases the flow capacity for greater system efficiency.
SIPP pipe lining rehabilitation technology can yield an estimated cost saving of around 40% when compared to direct replacement, which is the process of digging up the entire length of the pipe that needs attention and replacing it all. Another benefit that transcends cost: the ability to minimize inconvenience to consumers by relining water pipes rather than digging them up and replacing them. With our temporary water offering, water could be provided without interruption to your consumers, throughout the spray-in-place process.